top of page
goalie mask
INSTALLATION
TOOLS NEEDED
utility knife
hair dryer
screw driver
cloth
WELCOME TO OUR INSTALLATION PAGE.
Please note, if this is your first time applying decals,
TAKE YOUR TIME
Do not rush this process. Please watch the tutorial videos below and reach out to us if you have any questions.
do not try this process without an adult present
**PLEASE NOTE**
!!DO NOT CLEAN WITH ALCOHOL AFTER APPLICATION!!
INSTALLATION VIDEO 1
INSTALLATION VIDEO 2
TIPS & TRICKS
- If you stretch your graphic out too much you can shrink it back to size. Just hit it with the blow dryer for a few seconds.
- Once a decal has been applied, its good to give it some time to adhere before cutting off any excess. This will prevent lifting.
- Measure where you want to place each decal first.
- Make sure your utility knife is sharp. Cut the vinyl lightly, you don't want to scratch your goalie mask.
- Use the blow dryer consistently throughout this process, especially when stretching over slopes and ridges.
- ALWAYS have an adult present when applying and cutting graphics.
​
- Apply the vinyl around the edges of your helmet. This will help with any retraction that may occur.
OTHER VIDEO TUTORIALS
PAD VINYL
INSTALLATION
TOOLS NEEDED
utility knife
hair dryer
scotch tape
scissors
Before starting
clean your pads and remove any dust or puck marks
apply tracing paper
trace the pad shape you want to change
tape your shapes to the pad vinyl
then cut out each individual piece
apply each piece of vinyl to your pads
(if needed) use a utility knife to cut around any stitching
be cautious not to cut any stitching on your pads
blow dry your pads
this will give the vinyl a nice smooth finish
be care
Feel free to send us pictures when you're done
We are always looking for new content to post!
.png)
bottom of page